Apex Plus 3.1.0 Release & Manual

Follow

Comments

3 comments

  • Avatar
    Randy Cosby

    Can you clarify how to tell if I have "hardware ID 2"?

     

    At the command prompt run the command #model

  • Avatar
    Scott Chester

    Hardware ID 2 just recently started shipping in the past month or so. HWID 2 should have shipped with this new firmware on it. With the new firmware when you run the "model" command in the CLI, it will show you the hardware ID of the OMU.

  • Avatar
    Scott Chester

    An issue has been reported with using IBM on GE2 (SFP port) with HWID 1. It appears that IBM doesn't function when going in over the SFP and will only work for traffic going in GE1 with smart mode enabled. At this time, the workaround is to disable smart mode on both sides, save and reboot. This will allow the IBM to work on either port since the port mapping is disabled with smart mode off.

Please sign in to leave a comment.